No results
1
Add a screen
Vivy edited this page 2026-11-17 17:35:03 +00:00
Add a screen
A new device does not show anything until you approve it. This stops an unknown computer from joining your screens.
1. Start the device
Install the device as shown in Quick install, or switch on a device that is already installed. It connects to the server by itself. Until you approve it, the screen stays dark.
2. Approve it
Click Devices at the top. The new device is under Pending devices, with the name of the computer and its network address.
- Click Approve when you know the device.
- Click Block when you do not. A blocked device cannot connect.
The device moves to Approved devices.
3. Make a campus (once)
Every device belongs to a campus. If you have no campus yet:
- Click Settings at the top, then Campuses on the left.
- Under Add a campus, type a short Code (for example
NORTH) and a Name (for exampleCampus North). - Click Add campus.
4. Name the device and choose its campus
Go back to Devices. On the card of the device:
- Click in Name and type a name that tells where the screen is, for
example
Entrance hall screen. Click outside the field to save it. - Choose the Campus.
The panel shows Done. after each change.
The small labels on the card tell you more:
- Host — the name of the computer.
- Has a token: yes — the device has connected after it was approved.
- Playlist — the playlist it shows, or none assigned.


